www.megadrum.info

Hi everyone.
I was using firmware 20100827 56 inputs 644, and everything was working super.
When I update to 20101223 no matter what setting I use the pads are way TOO HOT.
I have pots installed on every pad and cymbal but megadrum is just out of control.
All gains low is ON but still the same problem.
Can you guys tell me what am I missing?
I have tried with settings on every pad but no luck.
I would put the old firmware back but I like custom names on pads and megadrum manager, and it will not work on older firmware on pads setting.
Any ideas????
Thanx.

As far as I remember I haven't changed inputs levels handling between August and latest version.

I' ve put the old version back and it's fine.
After updating again the same problem.
I don't have a clue.
I will put old version again.

When I clear some backlog I will look into it.

Thank you.

I have compared 20100827 and the latest versions and I don't see any changes which would effect sensitivity or signal level detection. I also tested both versions with my pads and I don't notice any difference in sensitivity or HighLevel detection.