finished soldering, plugged LCD => nothing on screen
Posted: Fri Dec 05, 2008 10:48 pmHi all,
I just finisihed soldering the PCB and the LCD. I haven't any connector yet. But I wanted to check that the stuff is ok until now. So I plugged the usb to my computer, but nothing happens:
I tryed to turn this 10k reistor potentiometer, but still nothing. So few question:
1 - is there a main swith to power it up (I guess no)
2 - Should I see it somewhere in the device manager (I m using vista)
3 - What are the check I can do to find out what the pb is?
Sorry to ask these dumb question but I'm a bit scared right now.
I just finisihed soldering the PCB and the LCD. I haven't any connector yet. But I wanted to check that the stuff is ok until now. So I plugged the usb to my computer, but nothing happens:
I tryed to turn this 10k reistor potentiometer, but still nothing. So few question:
1 - is there a main swith to power it up (I guess no)
2 - Should I see it somewhere in the device manager (I m using vista)
3 - What are the check I can do to find out what the pb is?
Sorry to ask these dumb question but I'm a bit scared right now.