www.megadrum.info

First!

Thanks Dimitri, Synthex and all of you who contributes to the Megadrum development in this forum, remarkable to say the least...

Then on to my questions:
I seem to have a problem with my optical hihat pedal controller - when I try to adjust the LowLevel and HiLevel range to achive no CC messeges to be sent in end positions, I can get it to stop at 127 pedal pressed down, but I don't get it to reach below 1 in the up posiotion (in other words it doesn't reach 0, both MCT and MidiOX shows 1 when pedal is in the open position). Is this ok or have I missed something?

The other thing that bugs me is that Megadrum sends out a "midi note on" in the midle of the CC range when I press down the pedal real slow, and thats sloooowly pressing down. How to setup Megadrum not to do that?

// Mattias

Make sure that the optics are completely unblocked when in this position. The slightest bit of blockage will change the voltage and give a "false" number.

toneking wrote:First!

Thanks Dimitri, Synthex and all of you who contributes to the Megadrum development in this forum, remarkable to say the least...

Then on to my questions:
I seem to have a problem with my optical hihat pedal controller - when I try to adjust the LowLevel and HiLevel range to achive no CC messeges to be sent in end positions, I can get it to stop at 127 pedal pressed down, but I don't get it to reach below 1 in the up posiotion (in other words it doesn't reach 0, both MCT and MidiOX shows 1 when pedal is in the open position). Is this ok or have I missed something?

This is ok.

The other thing that bugs me is that Megadrum sends out a "midi note on" in the midle of the CC range when I press down the pedal real slow, and thats sloooowly pressing down. How to setup Megadrum not to do that?

This is there to emulate a soft chick. When you really slow press a pedal, you inadvertently cause the pedal to go a slightest bit up somewhere in the middle. Once MegaDrum notices the pedal going up it assumes you stopped pressing it. And if it happens between a fully pressed position and a middle position MegaDrum registers it as a soft chick.

Ok, thank you for answering! What made me confused was that I read somewhere (maybe in the manual or in this forum), that the hihat pedal is supposed to send out a CC 0 in the open position, and that MCT shows the correct value (that being 0 when open), but no matter what I did trying to adjust the optical controller it wasn't possible to get MTC to show 0.

Anyway, thanx!

// Mattias


(Jman, I tried to totaly remove the "lightblocking" piece, also adjusting the amount of light with a trimpot, nothing helped!).