Has anybody configured a Pintech Dingbat?

[angr77]

A very nice tubular pad! If anybody has configured this pad in MegaDrum, Please post them here!

http://www.pintechworld.com/shop2011/sc ... product=95

Best regards

Anders

[angr77]

Hallo!! Anybody out there?

Here is a first try to configure a PinTech Dingbat. (It has a single piezo trigger so it was not too hard make it feel right)

Pinetech_Dingbat.PNG

Any comments are more than welcome!

[dmitri]

I'm pretty sure Retrigger Mask can be set much lower but I don't think it matters for such trigger since I hardly see it being used for press-rolls.

[angr77]

Thanks Dmitri.

I got it just perfect! Here is my settings. I did a new auto highlevel calibration + retrigger, threshold...which made the PineTech Dingbat to response in a much more dynamic way.

Pinetech_Dingbat2.PNG

Best Regards

Anders